Smart Film Installer Program: Training and Support

See How It Works

Trained Smart Film Installer

SFI builds long-term partnerships with film installers, offering dry-stick installation guidance, practical training and continuous support for adhesive smart film projects.

Dry-Stick Installation Method

Adhesive smart film is installed dry, without water. Clean glass preparation, careful positioning and patient handling are critical for quality.

Practice Before Commercial Work

Installers typically need three to four practice installations to reach consistent quality before actively selling the service.

Guides, Videos and Support

SFI provides installation guides, videos, tips, sample films, power accessories and practical support through the installer qualification process.

Partnership Brochure (PDF) →

Removing the protective layer before dry-stick installation

Qualification Steps

To qualify as a smart film installer, SFI recommends a practical path: start with powered samples, complete pilot installations, then deliver a first real client project before scaling commercially.

Step A — Start with Samples

Get small size plug-in samples to demonstrate smart film to designers, architects and potential clients, and to practice sticking film over glass.

Step B — Run Office Pilots

Install several small office windows with power access. Measure carefully, deduct 1/8″ (3 mm) from each side and mark handle or hinge cut-outs in advance.

Step C — Complete a Client Project

After a successful real client project, begin promoting the product commercially with confidence in installation quality and finish.

Trimming adhesive smart film at the glass edge

How to Install Adhesive Smart Film

01 — Unpack & Test

Open the box carefully, place every film on a clean long table, connect each piece through the transformer and confirm it works before sticking.

01 — Unpack & Test

Open the box carefully, place every film on a clean long table, connect each piece through the transformer and confirm it works before sticking.

01 — Unpack & Test

Open the box carefully, place every film on a clean long table, connect each piece through the transformer and confirm it works before sticking.

02 — Dry-Stick Expertise

No water is allowed. Thoroughly clean the glass surface and film. Use 90% alcohol to remove oily marks such as fingerprints, and handle edges patiently for a clean bond.

02 — Dry-Stick Expertise

No water is allowed. Thoroughly clean the glass surface and film. Use 90% alcohol to remove oily marks such as fingerprints, and handle edges patiently for a clean bond.

02 — Dry-Stick Expertise

No water is allowed. Thoroughly clean the glass surface and film. Use 90% alcohol to remove oily marks such as fingerprints, and handle edges patiently for a clean bond.

03 — Connect to Power

Connect the film to a 48 VAC transformer with switch, remote or both, then solder the film wires securely for reliable operation.

03 — Connect to Power

Connect the film to a 48 VAC transformer with switch, remote or both, then solder the film wires securely for reliable operation.

03 — Connect to Power

Connect the film to a 48 VAC transformer with switch, remote or both, then solder the film wires securely for reliable operation.

04 — Finish Edges & Profiles

Plan the visual finishes around the frames, rubber, tape or panels so film edges and wiring stay protected and the final installation looks professional.

04 — Finish Edges & Profiles

Plan the visual finishes around the frames, rubber, tape or panels so film edges and wiring stay protected and the final installation looks professional.

04 — Finish Edges & Profiles

Plan the visual finishes around the frames, rubber, tape or panels so film edges and wiring stay protected and the final installation looks professional.